Finish library

Choose your finish.

Seven ways to finish concrete, and where each one works best. We'll bring samples to the onsite quote.

Exposed aggregate

The top layer of cement is washed off after the pour to reveal the stones in the mix. Hard-wearing, grippy and good at hiding tyre marks and dirt.

Best for — Driveways, high-traffic areas

Care tip — Hose it down and reseal every few years to keep the colour of the stones rich.

Coloured concrete pressed with textured mats while it's still wet, so it takes on the look of stone, slate or sandstone.

Best for — Patios, steps, entries

Care tip — Sweep regularly and reseal when water stops beading on the surface.

Stamped concrete with a boarded timber grain. You get the look of decking without boards to rot, splinter or oil.

Best for — Pool surrounds, paths

Care tip — Rinse off chlorine and leaves, and reseal to keep it comfortable underfoot.

A decorative pattern and colour set into the surface to give a driveway or entry a feature look.

Best for — Feature driveways

Care tip — Clean oil spills early and reseal on a regular cycle to protect the colour.

Plain concrete finished smooth with a steel trowel or brushed with a broom for extra grip.

Best for — Slabs, sheds, utility areas

Care tip — Low fuss. A wash now and then and a seal if you want it to resist stains.

A thin decorative coating applied over sound existing concrete to give it a fresh colour and texture without pouring new.

Best for — Tired driveways, patios and paths

Care tip — Avoid harsh chemicals and recoat the sealer when the surface starts to dull.

A decorative edge or border detail that frames a slab, driveway or path for a finished look.

Best for — Edges, borders, entry features

Care tip — Treat it the same as the main surface: sweep, wash and reseal together.